DOORAUTE/P-Q Door, Automatic, Electric or Pneumatic - Quarterly

                                                       Man Hours 1.25
Items to Check & Initial Completion:

1.___ Check alignment of door and mechanism.  Inspect mountings, hinges, mats,
      and trim, weather stripping, etc.  Replace, tighten, and adjust as
      required.
2.___ Operate with power, observing operation of actuating and safety mats, door
      speed, and checking functions.
3.___ Check manual operation.
4.___ Inspect power unit, lubricate and tighten lines as required.
5.___ Check operation of control board relays, clean, replace, adjust contacts as
      required.
6.___ Inspect door operating unit, tighten lines, and adjust as required.
7.___ Clean and lubricate door pivot points.
8.___ On pneumatic or hydraulically operated door operators, check for correct
      operating pressures per manufacturer's instructions.
9.___ Clean up and remove all debris from work area.


Tools & Materials:

1.  Standard Tool kit.
    Plus  Insulated pliers and screwdrivers
          Wire strippers
          Wire crimpers
          Voltmeter - Ohmmeter - Milliammeter
          Clamp on meter(volt - ohm - amp meter)
          Soldering kit
          1/8" 25' fish tape
          Burnishing tool
2.  Lubricants.  Consult the Material Safety Data Sheets (MSDS) for hazardous
    ingredients and proper personal protective equipment (PPE).

Table of Contents    |    Next